Page 1 of 1

Posted: Tue Jul 04, 2006 10:31 pm
by Solo
Does anyone have some screenshots they can send me that show a stable, working Scope> Logic > Rewire to Reason setup ?

I have done a bit of work, yet the channels seem all wrong, the mono comes out of both speakers, the logic pans dont seem to work ect ?

At this stage I just want the Reason Drum machine, with separate channels for say 10 different reason mono drum channels into scope and into Logic. A screen shot of the three setups would be great.

Also any comments re the stability of the setup would be great.

Thanks Greg

<font size=-1>[ This Message was edited by: Solo on 2006-07-04 23:32 ]</font>

<font size=-1>[ This Message was edited by: Solo on 2006-07-04 23:32 ]</font>

Posted: Wed Jul 05, 2006 2:54 am
by petal
You have to run Reason in ReWire-mode into Logic first, and then from there into scope. You can't share the ASIO-driver between the two apps.

About stability, it's stable if you have a fast enough computer.