PlanetZ forums - scopeusers.com

I have one of the original Pulsar cards in my computer. I am running software ver 3.2 but would like to install Scope 4.0. I had this installed at one time but I can't remember what tweaks I had to do to get it to install.

When I get to the installation screen where I'm asked to enter keys, I import the allkeys.skf file (which is up to date with what I have), but the "continue" button never lights up. This is as far as I can get.

Here are the specs on my PC:

Windows XP pro
Pentium III, 1ghz, 512mb ram

Any help with this would be greatly appreciated!

Brian

If you don't get the next button it means you either do not have scope 4.0 software key activated or you need to update the ASPI layer for your windows. check adaptec website. for the latest ASPI.


for keys: Contact ralf (rb@creamware.de) with the SN of the Pulsar and request an activation for Scope 4.0. Ralf will email you the new allkey file needed to unlock the 4.0 version.

<font size=-1>[ This Message was edited by: ali on 2006-06-05 11:49 ]</font>

Yes...I remember getting confused about the whole ASPI thing. Is this just a matter of downloading and installing something?

make sure XP is up to date or install the latest ASPI layer

ftp://ftp.creamware.com/Software/tools/

or

http://www.afterdawn.com/software/cdr_s ... s/aspi.cfm


<font size=-1>[ This Message was edited by: ali on 2006-06-05 17:38 ]</font>