Posted: Thu May 11, 2006 5:15 pm
After having used stm 2448 mixer for some time, I finally sat down & read the manual, one thing in particular struck me from the manual
"Board IDs
If you have more than one DSP board
installed in your system, and you are
using numerous external I/Os with the
mixer, you can assign particular channels
to specific boards. Correctly configured,
this can relieve the DSP system greatly.
You can assign the first 12 mono/stereo
channels and the entire Master section
to one board, and the next 12 channels
(13-24) either to the same board, or TO
another. With the STM 4896 an additional
two groups of 12 channels can be
independently assigned."
but it doesnt tell you how to do this, I have two boards (lunaII & pulsarII), but if I click or type in the Board ID field nothing happens, are these assigned elsewhere? what am I missing?
"Board IDs
If you have more than one DSP board
installed in your system, and you are
using numerous external I/Os with the
mixer, you can assign particular channels
to specific boards. Correctly configured,
this can relieve the DSP system greatly.
You can assign the first 12 mono/stereo
channels and the entire Master section
to one board, and the next 12 channels
(13-24) either to the same board, or TO
another. With the STM 4896 an additional
two groups of 12 channels can be
independently assigned."
but it doesnt tell you how to do this, I have two boards (lunaII & pulsarII), but if I click or type in the Board ID field nothing happens, are these assigned elsewhere? what am I missing?
