PlanetZ forums - scopeusers.com

Hi
This is not a real problem, but I'd like to know if there is any way to select more faders in STM 2448 mixer and change their levels mantaining the differences between them. That is, if there are three faders with -24db, -10db, -7db I'd like to select them all at the same time and get -2db values for each one (getting -26, -12, -9) without changing their levels one by one. It would be very useful in a large project..
Sorry for my english
Thanks a lot in advance

Stefano

You need to group the faders. Underneath each channel fader there's another section with 2 square buttons (one with a 'D' on it) Underneath that, there's two text fields. The one on the left is for assigning that channel to a mute group. The one on the right, for assigning that channel to a fader group. You need to click, hold & scroll on these to select a group number. With say 3 faders assigned to group 1 you will get the results you're after.
You won't be able to change those 3 fader levels independently until you ungroup them again.

There's a picture/diagram on page 11 of the STM2448 manual which briefly explains the procedure.

Thanks a lot.
I will check it

Stefano