Page 1 of 1
Posted: Wed Feb 08, 2006 8:43 am
by Christos
Hello,
I just installed Scope 4.5 from 3.1c, and SFP keeps booting automatically after Windows. I have unchecked the active project at startup in the settings tab, but it keeps doind it. I would appreciate any suggestions.
Thank you
P4 3.0Ghz, Intel 875PBZ, 2 Gb Kingston, Matrox Parhelia, 2X80 & 160 WD, 2 X Pulsar II Plus, Nuendo 3.2, Gigastudio 2
Posted: Wed Feb 08, 2006 9:41 am
by arela
Windows > run > msconfig
uncheck SFP
(IT'S IN STARTUP FOLDER in msconfig)
sorry for GIANT FONTS
Posted: Wed Feb 08, 2006 2:47 pm
by ARCADIOS
hi christos! ti habaria?
the settings that you have unchecked is for using scopes project as default or startup each time scope lounches.
after installation, scope always is set to run with windows startup.
just uncheck in msconfig
Posted: Thu Feb 09, 2006 1:18 am
by geoffd99
Hi all
My 4.5 install didn't load the new plugins (for some weird reason CW couldn't figure out) so I have them all registered to 4.0.
But Startup is 4.5 (as above threads).
How do I change the Startup launch back to 4.0?
Thanks!
Posted: Thu Feb 09, 2006 2:28 am
by Christos
Hallo guys
That was it. Thanks for the support.
Posted: Thu Feb 09, 2006 2:24 pm
by arela
Hi geoffd99
Are you shure your 4.5 files are complete.
Have you tried to install the plug-in later.
Or is it the folder that is SFP4?
Scope 4.5 installed over 4.0, so that's ok.
Posted: Fri Feb 10, 2006 1:01 am
by geoffd99
sfp4.5 is in its own folder, and starts up fine with Windows.
sfp4.0 is also OK, and to use it, I just stop 4.5 and start 4.0.
But this would be easier if it started with XP Startup.
The plugins didn't register with 4.5, no one at CW could figure out why, so they registered them to 4.0.
This is fine, except I have a useless v 4.5.
Not a major problem though.
Posted: Sun Feb 12, 2006 10:12 am
by geoffd99
Yes this worked fine thanks!