PlanetZ forums - scopeusers.com

Hi all and thanks to Garyb for the advice on my earlier post.

However...

Yes, I see how Cubase tracks can be sent to the Luna II fx etc and then re-routed back into Cubase and saved as a separate track. But it does not seem possible to send one track only to the sound card unless the track is soloed...and that defeats the purpose of hearing the Luna fx in the complete mix. As far as I can see, Cubase VST 5 does not allow individual tracks to be sent to individual channels of the STM1632. It sends the whole mix via the master output.

What I want to do is use the Luna fx on individual tracks that are routed back into Cubase so that I can save them. If this can't be done I can't quite see the advantage of the fx on the sound card.

...or am I missing something?? (Wouldn't be the first time)

Cheers

Neil

You can assign a different asio ouput at cubase mixer, you must have enabled them first

Thanks fra77x for the prompt reply.

It makes a lot more sense now! I am a little embarrassed!
I'll spend some more time on this and hopefully use more of the potential of the system.

Thanks again

Neil