Page 1 of 1

Posted: Tue Jan 03, 2006 11:29 am
by peli_can1
My first post in this hopefully very helpful forum :smile:
I have two Scope Project cards (one classic and one XTC retrofitted with ADAT I/O). I run Windows XP SP 2. In the scope application all works fine, I run guitar throught preamp->spdif in->scope->spdif out->g-major. But when I run the same setup in Cubase SX 3 I get sound input on the meters, but no output. I also cannot playback ordinary sound files, mp3's and so on, it says "The hardware caonnot playback this kind of file" (on .mp3 and .wav files)!! Any ideas??
Regards,
Peter

Posted: Tue Jan 03, 2006 12:39 pm
by arela
welcome Peter

For Cubase:
Pulsar2 SP-DIF SOURCE > scope mixer chn 1
From mixer chn 1 (or MIX L/R if you don't intend to use direct out) > ASIO DEST
...now you have signal to Cubase, then
ASIO SOURCE 1 > scope mixer chn 2
...now you have signal out of Cubase



To play from eg mediaplayer, you need to connect a wave source to the mixer.

Posted: Tue Jan 03, 2006 4:02 pm
by peli_can1
Thanx for reply!
But is it not possible to run a media player, e.g. Winamp without having SFP installed (just using WDM drivers?)
Regards,
Peter

Posted: Tue Jan 03, 2006 4:05 pm
by garyb
no. scope is not a simple windows soundcard. scope is a hardware environment, the routing window is required. for music production, this is a good thing. for games and such, it might be a bit of a bother.

Posted: Tue Jan 03, 2006 5:32 pm
by peli_can1
Big thanx!!!

Posted: Sun Jan 08, 2006 2:49 am
by H-Rave
I've always got an Asio source, a Wave source and an Analog source going into the mixer on my Startup File.