PlanetZ forums - scopeusers.com

Hello

I have bought a secondhand Pulsar 2, within the allkeys file i clearly see Modular 2.

What happens when i install Scope 4.0 is that i get two messages. First:

cannot install modular2.
please check your installation

short after that this appears:

initsialising of modular 2 successful

Yet, when i click on the Modular2 section in the routing window there is no menu appearing - nothing to click.
What am i doing wrong?

I have tried downloading a 1kb modular2.oxe file and placed it in App / Oxe, but i just get the same message as when installing Scope 4.0. And after that, still no modular2 can be opened. There is a tab that says modular2 but nothing happens when i click it.

Please help

AFAIK, the modular2 pack is a separate download. What you have IMO is just the registration modules. Check out their ftp/site again...

Do you mean the 1kb modular 2.oxe that can be found at this adress?

ftp://ftp.creamware.de/Software/Scope_f ... okeys_OXE/

As i said i have tried installing this file but
i get the same messages...

After installation, you have to upload all your modules into the MII folder, so you have the instruments and pieces to build new ones at your disposal, within SFP. Check the installation and installation instructions. If you don't have the modules inside the MII folder, you have not properly installed and uploded them to your SFP directory.

On 2005-12-21 11:25, Micronesia wrote:
Do you mean the 1kb modular 2.oxe that can be found at this adress?

ftp://ftp.creamware.de/Software/Scope_f ... okeys_OXE/

As i said i have tried installing this file but
i get the same messages...

No. He means this:

http://www.cwaudio.de/download/software ... E_v40_.zip

The Modular2 modules are not included in the Scope 4.0 base install.

Problem solved.
Thank you very much