Page 1 of 1
Posted: Thu Oct 27, 2005 1:38 am
by ScofieldKid
I'm assuming that at any time you can select which of the A16Ultra channels are either connected as IN or OUT, based on the linkings in the Scope routing window... assuming dual Z-link connectors.
So for example, you could have 14 line-ins, and 2 line-outs. Yes?
Posted: Thu Oct 27, 2005 1:54 am
by garyb
sure!
it's full duplex. use iins and outs in any combination/configuration.
<font size=-1>[ This Message was edited by: garyb on 2005-10-27 02:55 ]</font>
Posted: Thu Oct 27, 2005 8:16 am
by astroman
... which means that you don't have to sacrifice inputs for outputs (as the 14/2 suggests)
as GaryB wrote, any combination applies, so 16/2 is also valid
cheers, Tom
Posted: Thu Oct 27, 2005 10:53 am
by symbiote
Actually, the 16U has 16 inputs and 16 outputs. You can't use an input as an output, nor the opposite.
Posted: Thu Oct 27, 2005 1:36 pm
by ScofieldKid
Do you mean I can have 16 ins coming into the Scope, and at the same time I could have say 4 outputs going out?
I thought that the converters in the box limitted you in such a way that at any given time, you can only use a converter as either an input or an output. But if it's the case that you can do 16-in recording, and also monitor outputs at the same time...
Wow!
Posted: Thu Oct 27, 2005 4:46 pm
by symbiote
Yep, 16 in and 16 out at the same time. 1U, sounds awesome, you know you want one =P.
Posted: Thu Oct 27, 2005 5:45 pm
by next to nothing
and just to clarify, i guess those are MONO ins and outs (this might be stupid but just wanted to mention it. and i needed a post #600
).
<font size=-1>[ This Message was edited by: piddi on 2005-10-27 18:46 ]</font>