PlanetZ forums - scopeusers.com

Hello,

The Modular III on my Mac Scope 4 install behaves in such a way that it's impossible to use. When opening an empty modular patch it's not possible to add modules for about 8 times. At the ninth try the module I wanted to load the first try loads, continuing with the second and so on. After a while, Scope crashes without any warning or error. Is there a solution to this problem?

Dodge

<font size=-1>[ This Message was edited by: dodge on 2005-10-04 10:33 ]</font>

Dunno. Apart from using other people's patches (thanks megerov) i have given up using ModIII. i don't even get any drop down menus to select the modules, just blanks. i think SCOPE4 has been overall a good upgrade apart from ModIII and STS, which seem to not work on Mac as they should.

i hope someone can help you, but it's not me i'm afraid

Have you tried switching to classic window mode? The classic mode allowed me to select modules like I described. The other mode doesn't let me select anything at all.

Dodge