Page 1 of 1
Posted: Wed Jul 27, 2005 10:40 am
by helldriver
i have a behringer adat interface and a minidisc. both have opical connections
the behringer is adat and minisdisc is spdif
is it possible with pulsar (it has per card two optical ins /outs).
if not, is it possible with two pulsars? (one pulsar has the adat connection, the other one has the spdif (optical) connection?
thanks
Posted: Wed Jul 27, 2005 10:54 am
by at0m
[...i better pass for someone who actually has that setup;]
_________________
more has been done with less
<font size=-1>[ This Message was edited by: at0m on 2005-07-27 18:39 ]</font>
Posted: Wed Jul 27, 2005 5:24 pm
by valis
Using a single board you could probably switch the spdif between the different sources (although not all at once).
<font size=-1>[ This Message was edited by: valis on 2005-07-27 18:25 ]</font>
Posted: Wed Jul 27, 2005 7:30 pm
by Liquid Len
On 2005-07-27 11:40, helldriver wrote:
i have a behringer adat interface and a minidisc. both have opical connections
the behringer is adat and minisdisc is spdif
is it possible with pulsar (it has per card two optical ins /outs).
if not, is it possible with two pulsars? (one pulsar has the adat connection, the other one has the spdif (optical) connection?
thanks
Yes it is very possible to do this. I have a Pulsar II and use ADAT A to run SPDIF to an amplifier, and use ADAT B to talk to a Behringer 3216 mixer.