Posted: Fri Jul 22, 2005 1:25 pm
Okay, it has been a long while, but I'm finally getting the studio on board this boat in a much more complete and concise system. I'm now running a scope professional with Z-Link plate, and an A-16 Ultra plugged into that. Lots of other fun stuff too.
The problem is, I've switched out the I/O plate on this card from the Plus plate to the Z-Link plate, and now have a few problems (needless to say, I haven't switched out the drivers.) I started looking at switching out drivers and the software, etc, and realized that it was going to require a lot of research before I get started.
What I want to know, basically, is if it's okay to just uninstall and reinstall the driver, or should I reinstall the Scope 4, or what? what would be the best way to go through with this as things worked before I switched out the I/O plates, and I don't think there's really a problem with anything else in the setup.
Be well,
-Tak
<font size=-1>[ This Message was edited by: takieda on 2005-07-22 14:25 ]</font>
The problem is, I've switched out the I/O plate on this card from the Plus plate to the Z-Link plate, and now have a few problems (needless to say, I haven't switched out the drivers.) I started looking at switching out drivers and the software, etc, and realized that it was going to require a lot of research before I get started.
What I want to know, basically, is if it's okay to just uninstall and reinstall the driver, or should I reinstall the Scope 4, or what? what would be the best way to go through with this as things worked before I switched out the I/O plates, and I don't think there's really a problem with anything else in the setup.
Be well,
-Tak
<font size=-1>[ This Message was edited by: takieda on 2005-07-22 14:25 ]</font>