Page 1 of 1
Posted: Fri Jun 24, 2005 3:31 pm
by youngsta
Hey y'all got a little question...
I own a pulsar II cad and i recenly puchased a scope home card. How should i connect these cards to make them function as 'one' ?
Thnx
Posted: Fri Jun 24, 2005 3:34 pm
by hubird
Posted: Fri Jun 24, 2005 3:44 pm
by youngsta
Lost the manual so that's kind of a bummer : (
Posted: Fri Jun 24, 2005 3:49 pm
by alfonso
You need an STDM cable that your reseller should provide.
Posted: Fri Jun 24, 2005 3:54 pm
by hubird
you need a 'STDM' cable to connect both cards at the STDM connectors.
SFP will immediately and without any problems see both card's `DSP's as 'one'.
With two cards, use the 'ends' of the three-point cable, as termination is involved.
Ask your dealer or order one from CWA.
<font size=-1>[ This Message was edited by: hubird on 2005-06-24 16:55 ]</font>
Posted: Fri Jun 24, 2005 3:59 pm
by Guest
