PlanetZ forums - scopeusers.com

I have a luna1 card and in cubase and logic the
latency was 3ms I have now added a pulsar1
card and the latency now will not go below 14ms

Can any one help me

Old Pulsar 1 cards, if set as main cards can't go lower in latency. But I have a P1 together with 2 second generation cards and I can go down to very low latency if I want.

In the paper manual there should be a chapter about editing a line in the cset.ini file (open it with notepad) for swapping the order in wich the cards are recognized by your system, but I don't have it now.

You could instead swap card position in the pci bus, this will very probably cure the issue.

If you do so, I recommend first to disable the startup project load when booting windows (reboot to check), then to uninstall card drivers, after that you swap card positions, reinstall the drivers, re-enable startup project (if you need it) and should be fine.

Just a curiosity...when you open the DSP usage panel, wich card is listed first now? if you have it properly you should see DSP's like this : 1/1 1/2 1/3 2/1 2/2 2/3 2/4 that means that the 3 dsp card, Luna, is the first one.

Now that things are wrong you should see 1/1 1/2 1/3 1/4 2/1 2/2 2/3, where the old P1 shows as first.

How is it?

Thanks for the info I reinstalled the drivers and its back to 3ms in xtc mode. But now I cant seem to get it to go in 96khz it says the stdm cable on device 1 is missing

And have you got one? If not - it's required if you have >1 card. If you have it installed then you have to reseat it. Hope this helps

Got one cable connected with only the outer connecters works in 33 44 and 48kHz just not 96kHz