Page 1 of 1
Posted: Tue Jun 14, 2005 11:33 am
by Music Manic
Why is it,that,when I have a stereo signal,and disconnect the left incoming signal I have nothing coming out of the left?
When I do it vice versa I can still hear Right signal.
Why does left need the right input also?
What is the signal flow?
Any ideas?
Thanks
Posted: Tue Jun 14, 2005 1:02 pm
by cream
finally a problem I don't have
sorry mate
Posted: Tue Jun 14, 2005 2:04 pm
by samplaire
a ground problem? Badly made cables? Try to replace them with another pair and reproduce the problem....
Posted: Tue Jun 14, 2005 2:58 pm
by Music Manic
Sorry,didn't explain properly.
It's an internal setup.ASIO,Wav source etc to stereo channel(stm mixer)IN.
Posted: Wed Jun 15, 2005 12:01 am
by at0m
I think connecting the Left input activates the channel, it lets the mixer know which is active. A switch to activating the channel also means it doesn't take much dsp when it's not activated. That's why an empty 2448 doesn't eat dsp untill you connect lots of inputs...
Any insert in the stereo track with 'mono in' option will take that from left too, if that may consolidate you
Posted: Wed Jun 15, 2005 5:34 am
by Music Manic
Thanks at0m.
Posted: Wed Jun 15, 2005 7:55 am
by samplaire
On 2005-06-14 15:04, samplaire wrote:
Try to replace them with another pair and reproduce the problem....
This would be very difficult to reproduce in this case