Page 1 of 1
Posted: Fri Jun 10, 2005 7:23 pm
by lovenara
concerning the tip:assigning multiout of SX to mix with each SFPmixer's channel
http://www.planetz.com/forums/viewtopic ... forum=3&19
"use to try that great sound but problem is
Sx can't export all of other bus into one wave ,except the masterbus
So i have to open another sound recorder like
samplitude to reocrd all the outs?
Is there other way around?"
thnx
nara
Posted: Sat Jun 11, 2005 1:03 am
by alfonso
I have all my Cubase tracks on separate busses, I mix in Scope, then I route the mix out of my Scope mixer to a stereo Asio destination Channel and record back a track to Cubase. All this is done at 32bits. I will find this 32bit mix track in Cubase audio folder.
After this, I close Cubase, the Composing-Mixing Scope project, then I open a preset Mastering Scope project, where I have a Control Room device and some mastering plugs cascaded (usually Graph EQ and Optimaster, but it could change) that feed the Cntr.Room at different stages, so I can monitor alternatively pure ASIO, only EQ, EQ+ Optimaster, If is needed (usually never) EQ+Optimaster+PsyQ...and so on. I load a new Cubase template, I import the 32 bit mix, adjust the finalizing plugs in Scope, and re-record a new track in Cubase connecting Cntr.Room output to ASIO destination.
At that point I have a new finalized 32 bit track, I add in cubase the U22hr as insert and make my 16bit mixdown.
You don't need to open other apps.
Posted: Sat Jun 11, 2005 10:28 am
by lovenara
thnx lot never knew it b4
Posted: Sat Jun 11, 2005 4:10 pm
by lovenara
hi
would i be lucky enuff to hear samples of your mastering with optimiser?
thnx
lovenara