Page 1 of 1
Posted: Thu Jun 09, 2005 6:16 am
by american_idol
I can't not route each audio track in cubase to sts 2448 mixer. All sound are assigned to channel 1 in STS2448.
In routing window, I use ASIO2 24 bit source and dest as general. I don't know what configuration that I have to set in cubase such as bus output etc. , pls advise.
I use cubase sx2.2.035
thank you in advance
Posted: Thu Jun 09, 2005 8:34 am
by garyb
well, you have to have the number of asio channels you want in scope BEFORE opening cubase, you must enable the i/o in the vst connections dialog in cubse before you can use them, you must choose the proper outputs for each track in cubase and you must read the manual before proceeding.....
Posted: Thu Jun 09, 2005 11:45 am
by Casper
You can switch or reload the ASIO driver as well in Cubase. Just reselect the Scope Asio. Then cubase asks to switch or keep. Select Switch to reload. This way you can easaly add scope channels in the routing window and "resetting" the ASIO settings in cubase. They only thing to do extra is add the tracks in "VST connections". And voilla .
cheers,
Casper
p.s. (edit) "Scope channels" --> "Asio channels"
<font size=-1>[ This Message was edited by: Casper on 2005-06-09 12:47 ]</font>