Page 1 of 1
Posted: Thu Jun 02, 2005 2:06 pm
by garygiles
Hi All
Can someone tell me if there is a setting so I can always the see the LiveBar on startup of my PC. It's useful to see when Scope has finished loading all its devices so I don't open any other programes before Scope has finished.
Regards
Gary
<font size=-1>[ This Message was edited by: garygiles on 2005-06-02 15:08 ]</font>
Posted: Thu Jun 02, 2005 2:46 pm
by Guest
while the live bar is present on your screen make sure that you save the project under setting,to load at start up.
in the live bar go to set /settings/projects then click on save project as startup
Posted: Thu Jun 02, 2005 3:13 pm
by hubird
Posted: Thu Jun 02, 2005 7:19 pm
by garygiles
Antar
Thanks for your suggestion but I am sure I have tried this a 1000 times already but it only ever shows up on the startup tray 1st then I have to click show.
I have seen it show up but then it just stopped and I'm not sure why.
I will try it again when I get back in to work.
Regards
Gary
On 2005-06-02 15:46, antar wrote:
while the live bar is present on your screen make sure that you save the project under setting,to load at start up.
in the live bar go to set /settings/projects then click on save project as startup
Posted: Sat Jun 04, 2005 1:45 am
by garygiles
Hi
Fixed the problem by editing the RegEdit file.
G.
<font size=-1>[ This Message was edited by: garygiles on 2005-06-04 02:45 ]</font>
Posted: Sat Jun 04, 2005 4:07 am
by alfonso
On 2005-06-04 02:45, garygiles wrote:
Hi
Fixed the problem by editing the RegEdit file.
G.
<font size=-1>[ This Message was edited by: garygiles on 2005-06-04 02:45 ]</font>
Could you post how in the Tips & Tricks forum?
Posted: Sat Jun 04, 2005 6:27 am
by garygiles
Hi
I fixed it by going into
HKEY_LOCAL_MACHINESOFTWAREMicrosoftWindowsCurrentVersionRun
and then removing -s at the end.
G.
