Page 1 of 1
Posted: Thu May 19, 2005 2:23 pm
by MikeRaphone
I dont know why but if i connect individual outputs of instruments to the mixer they peak happily no matter what i do with volume knob(on the eds). Mix output works normally.
Any clues?
Thx
Posted: Thu May 19, 2005 9:52 pm
by garyb
afaik, volumes only work for the mix out. you can use the channel gain controls for the individual outs.
Posted: Sat May 21, 2005 2:37 am
by MikeRaphone
Thx Gary,
Kick and snare go red though, and i am not sure if they're scorched or not, i put a limiter on it and recorded it, but i wanted to know if it's just a bug or is the signal actually distorted...
Otherwise it's one sexy drum machine
Posted: Mon May 23, 2005 5:14 pm
by MikeRaphone
Ergh... so is it a bug?
Posted: Mon May 23, 2005 5:48 pm
by hubird
naoow, can't be
Did you try to rebuild the project?
I had something similar lately, it was when I loaded the demanding Solaris.
I reloaded Cubase and SFP (after refreshing the prefs of Sound panel and Cubase) to be sure the ASIO communication was reset.
After I did that I didn't see that bug again