Page 1 of 1
Posted: Wed May 04, 2005 4:06 pm
by diminu
Hi,
is there any possibility to run a standalone synth together with a sequenzer in Scope?
Posted: Wed May 04, 2005 4:13 pm
by paulrmartin
Drop a couple of Wave Sources in your Scope project and assign outputs in your Standalone to one of them and sequencer to the other.
Easier than that, Drop an ASIO source in your project, assign 4 outputs in it and assign the standalone and sequencer output to their respective slots.
<font size=-1>[ This Message was edited by: paulrmartin on 2005-05-04 17:16 ]</font>
Posted: Wed May 04, 2005 4:32 pm
by diminu
@paulmartin
Hi,
thanks for the reply. I´ve done so like you recommended. But whenever I open the standalone synth i get the Error: " Scope fusion is not running or ASIO source or ASIO dest are not included in your current system". But they are!
Greetz
diminu
Posted: Wed May 04, 2005 4:46 pm
by Music Manic
On 2005-05-04 17:32, diminu wrote:
@paulmartin
Hi,
thanks for the reply. I´ve done so like you recommended. But whenever I open the standalone synth i get the Error: " Scope fusion is not running or ASIO source or ASIO dest are not included in your current system". But they are!
Greetz
diminu
Are you on Scope V4.0?
Seems to create this problem all the time for me.Re-install Pulsar card drivers and try again.
Posted: Wed May 04, 2005 6:22 pm
by Guest
Asio Source/destination must be loaded in your creamware routing windows before you start your sequencer. and don't close creamware software.
<font size=-1>[ This Message was edited by: antar on 2005-05-04 19:23 ]</font>
Posted: Wed May 04, 2005 7:34 pm
by paulrmartin
Make sure your Scope is not running in XTC mode.
Posted: Wed May 04, 2005 8:14 pm
by garyb
you can only connect asio to one app(asio's not multiclient). the other must use a wav module.
Posted: Wed May 04, 2005 10:21 pm
by hubird
exactly...
Posted: Thu May 05, 2005 2:25 pm
by diminu
O.K.
Thank you
diminu