PlanetZ forums - scopeusers.com

Can anybody post a project which enables me to play several CW synths at one time with only one keyboard?

Thanks in advance

diminu

Just load all syths you wanted to play,then play.
cheers

Hoi,

Are you familiar with MIDI? Set different MIDI channels in each synth. Set keyboard to same channel as the one you want to play, or use the MIDI channel changer from alfonso, see Devices forum.

More on MIDI: http://www.borg.com/~jglatt/tutr/miditutr.htm

I hope that solves part of your problem.

For the rest. just connect each synth's output to a mixer channel.

at0m.

On 2005-03-25 15:25, at0m wrote:
Hoi,

Are you familiar with MIDI? Set different MIDI channels in each synth. Set keyboard to same channel as the one you want to play, or use the MIDI channel changer from alfonso, see Devices forum.

More on MIDI: http://www.borg.com/~jglatt/tutr/miditutr.htm

I hope that solves part of your problem.

For the rest. just connect each synth's output to a mixer channel.

at0m.

Hi, thanks for your reply.
I think I´m rather familiar with midi.
But I will explain my problem.
I´m running Logic 5.5.1 and I´ve put an environment to launch let´s say the minimax or B-2003. I would like to play for example 3 instances of the B-2003 ( upper. lower manuals & pedals)with different presets. So how can I figure a project to play this. I´ve connected 3 keyboards via Emagic AMT 8 and I would like to launch diffrent synths or e.g. 3 instances of the B-2003. In the CW projects I can only set one midi output.
Any idea?

I suppose the B-2003 has 3 channels, one for each range.
If so, then merge all 3 keyboards with the AMT to Pulsar MIDI Source, to the B-2003. Then on each keyboard, set the MIDI channel for corresponding section of B-2003.