Page 1 of 1
Posted: Thu Mar 24, 2005 9:24 pm
by Garry
I've been having a variety of issues with my Pulsar 1 and SFP4.0. The most annoying one is that I have a Master Verb connected to aux 1 on an STM 1632 mixer. The aux send goes to the left input on the reverb and the stereo outs of the reverb go to the aux returns. Works fine.
I then save my project, reopen it, and the reverb connections are gone! Every stinking time. It's like they aren't being saved with the project or something.
Any suggestions?
Posted: Thu Mar 24, 2005 11:01 pm
by garyb
if you're saving the project correctly, they should stick(they do for me every time)....
Posted: Fri Mar 25, 2005 5:55 am
by Stige
This is a confirmed bug with STM1632 I think.. Happens to me too and several others I presume.
But the problem is only with graphics, your aux should still work like before, although you can't see the wire.
Posted: Fri Mar 25, 2005 6:02 am
by at0m
Indeed, Stige
Posted: Fri Mar 25, 2005 10:52 pm
by Garry
Thanks for the replies. To be honest, I never tried using it in that state. I saw the missing wires in the routing window and figured they were disconnected. Would that explain why I get hourglasses when trying reconnect them? Seems I have to fight with the devices to get the crosshair cursor to reconnect the ins and outs.
Posted: Sat Mar 26, 2005 5:44 am
by at0m
Indeed, the same hour glass as if it were connected already - which it is
Posted: Sat Mar 26, 2005 6:39 am
by garyb
glad to know this. i don't use the 1632 mixer very often. usually i use the 2448.
Posted: Sun Mar 27, 2005 9:01 pm
by MrV
Yes , it is graphics only .
I enquired about this a few years ago ...
Is there bug fix for it yet ?
Cheers ,
MV
Posted: Sun Mar 27, 2005 10:50 pm
by at0m
Nope.