Page 1 of 1
Posted: Wed Mar 16, 2005 12:23 am
by eliam
Everything seems fine with scope, the asio modules are in the project but nuendo says "can't load asio drivers".
I have reinstalled scope a couple of times as well as nuendo, without success...
Any hint as to how to fix this?
Thanks!
Posted: Wed Mar 16, 2005 8:58 am
by at0m
Normally, ASIO is installed with the client, so Nuendo. When the problem presents itself, I've always gotten away with it by re-installing the latest update of [Cubase].
Also, have you tried opening Nuendo with Pulsar set to samplerate --? Slave SFP to something that has no incoming clock, and Nuendo will, again, say it didnt find any drivers. That also resets ASIO, but on another level than the re-install.
For example, after a Nuendo crash when SFP thinks Nuendo is still using the drivers and upon re-opening Nuendo complains it doesn't find ASIO.
More than that I can't think of :/ Good luck, Eliam!
Posted: Wed Mar 16, 2005 4:13 pm
by garyb
reinstall the scope drivers in the device manager...
Posted: Wed Mar 16, 2005 5:12 pm
by eliam
Thanks for the tips, but neither of your suggestions worked... I'm clueless here... I guess I'll reinstall my system from scratch unless I fix it quickly...
Thanks anyway!
Posted: Wed Mar 16, 2005 10:28 pm
by Music Manic
This constantly happened to me when installing scope v4.0.
I got project without mixer too.
Tried re-install then got no registry key found error.
Can't remember how I got around it bit I didn't start Scope when it asked.
Think I re-installed drivers then scope exe.
Posted: Wed Mar 16, 2005 10:43 pm
by valis