PlanetZ forums - scopeusers.com

Just reloaded Scope v4.0 to new partition(XP),Started it up and there was no mixer in project.I then loaded sequencer and it didn't have any ASIO choice available even though I had it in Scope project.
This has happened to me before and can't work out why.
Are reference directories to blame?

Thanks

If it's a new Scope 4 install, have you removed the Read-Only attributes from the Devices and DSP dirs?

Sounds more like board communication error (poor PCI contact, PSU not providing enough power, stdm cable loose, irq conflict etc).

format & reinstallation
cheers