Posted: Sun Feb 13, 2005 9:12 pm
Scope 4.0 and Sonar 3.1.1
I have been using a Pulsar I card for over five years.
I recently purchased another Scope card, a "Project" card.
I realize that we don't have many people here who use Sonar, but here is the situtation. I created a routing with 1 "wave source" and 9 "wave destinations".
After booting Sonar and profiling the drivers I am told that I have a "Pulsar II" card with 12 in and 12 out. WTF!?
I tried creating an even simpler project with just one wave source and one wave destination. Sonar still profiles it as 12 in/out. I am confused.
This sort of thing never happened on my old system with Scope 4.0 and Sonar 2.2. Sonar always sees however many sources and destinations as are in the project.
If anyone has already been through this and has some suggestions I'd really like to hear from you.
R
I have been using a Pulsar I card for over five years.
I recently purchased another Scope card, a "Project" card.
I realize that we don't have many people here who use Sonar, but here is the situtation. I created a routing with 1 "wave source" and 9 "wave destinations".
After booting Sonar and profiling the drivers I am told that I have a "Pulsar II" card with 12 in and 12 out. WTF!?
I tried creating an even simpler project with just one wave source and one wave destination. Sonar still profiles it as 12 in/out. I am confused.
This sort of thing never happened on my old system with Scope 4.0 and Sonar 2.2. Sonar always sees however many sources and destinations as are in the project.
If anyone has already been through this and has some suggestions I'd really like to hear from you.
R