Page 1 of 1
Posted: Sat Feb 05, 2005 9:52 am
by elliot
hi chaps
just a quick question before i go forthwith and get a second card.
is it possible to use one card in xtc mode and use the second as normal, ie with the routing capabilities?
Posted: Sat Feb 05, 2005 10:43 am
by valis
Not in the same system.
Posted: Sat Feb 05, 2005 1:50 pm
by garyb
the computer sees the two cards as one.
Posted: Sun Feb 06, 2005 12:39 pm
by elliot
then whats the point of xtc then? surely you need a card to record/playback etc
Posted: Sun Feb 06, 2005 12:54 pm
by at0m
The inputs and outputs of your Scope hardware will be directly available to Cubase, in XTC mode.
Posted: Sun Feb 06, 2005 2:00 pm
by valis
The inputs/outputs are available and you can even setup custom routing options in your xtc 'project' that is loaded by the scope 'XTC' software at runtime (when your sequencer starts).