Page 1 of 1
Posted: Fri Jan 28, 2005 10:05 am
by Alfonso Fearless
Hi I'm trying to get Scope 4.0 home, cubase sx 2.0 and Reason 2.5 to all work together. I can get cubase and scope in xtc mode to work, but reason then won't work. I can get reason and cubase to work together through rewire but not in xtc mode. And as I can't have scope open to try projects out with cubase running, I'm just guessing. Can anybody help with a project for this...(or just talk me through making my own!).
Many thanks!!
Posted: Fri Jan 28, 2005 12:33 pm
by arela
hi, since i don't use xtc, i can't give you any hints about that, but i use SX, SFP and Reason. together.
(even SFP, Audition and Reason works nicly)
The main q is if Reason can run in xtc mode.
(2. q is why xtc?)
Mostly i use 3-6 asio sources into scope, for Reason. I need to activate those in Reason and Cubase, as you know.
Anyway, since a lot of people here prefere xtc, lets hope Reason 3 will solve this problem, if it's a Reason problem.
----------------
----------------
Posted: Sun Jan 30, 2005 8:57 am
by Alfonso Fearless
Thanks for your advice, I'm going to try and work it through again.
I don't suppose there is any chance of a screen shot of your non xtc project arela? It would help me loads just to see one working solution.
Wish me luck..
Many thanks again!
Posted: Mon Jan 31, 2005 5:02 pm
by arela
send me a mail, i'll send some pics
Posted: Mon Jan 31, 2005 6:36 pm
by valis
Why aren't you rewiring Reason into Cubase SX? This would seem a far better option as you'll get full midi control & automation over Reason from within Sx as well as being able to route all software audio through a common interface.
Posted: Sat Jun 04, 2005 10:34 am
by raztalove
bump...
Anyone ever figure this one out? Can Reason be used in conjuction with cubase in XTC mode? That would be huge.
Anyone?
Posted: Sat Jun 04, 2005 1:22 pm
by hubird
just as Valis says