PlanetZ forums - scopeusers.com

hi. excuse my bad english.

I'm using pulsar II 24 adat with three behringer ultragain ad/da-converters. So far so good. My problem:

Direct monitoring works on all 24 channels, also recording in multi-record-mode (cubase vst) on 24 channels simultanously. But when I play back the tracks, I can only hear output on asio pairs 1 and 2, all others remain silent. I have tried different asio2-devices in sfp, but none is working. So when I want to mix a song finally, I have to take an asio1-device. Is there a way to workaround?

thanks in advance.

Are the busses activated in Cubase?

Open the master mixer. You see the master (1L/1R) and the additional busses (2L/2R, 3L/3R...) correspondig to your ASIO-outs in Scope-Project.
There is a green field on this channels. It must lit. If it is dark the channels are muted.
Click on it.

Yes, they are. When I use Asio1 source and Asio1 Dest in pulsar setup everything works fine. But Asio2 devices don't do the job though direct monitoring is working on all 24 channels.

Sorry, I didn't read it.

Check this out:
Open the mixer.
Under each channel there is the bus to which this channel is routed. "bus3" etc.
Set it again to "bus3". Does it work then?

And yes ASIO2 seems to be buggy.
I sometimes have the problem that the channels "forgot" they bus during "direct monitoring" and reactivating the bus helps.
I'm interested if this problem correlates to yours.

I'll try it and tell you tomorrow evening. thank for reply!

hi again. tried it. the only functional output is the left channel of asio pair 1/2. any other suggestion?