PlanetZ forums - scopeusers.com

Can someone explain how Scope numbers the boards? I cannot see any systematic.

My configuration is:

PCI 2: Pulsar SRB
PCI 3: Pulsar II
PCI 4: Pulsar I

It was simply triel-and-error to make the pulsar II to the first card by editing the cset.ini.
I cannont distinguish the 4DSP card from each other in the dsp load window.
Does it matter if pulsar or pulsar SRB is the second card?

Can someone explain what "host" means? The entry: board0=host or so? Changing to board1 doesn't make any difference...

I normally have big project. I normally use as much as I can. Even 14DSP are not enough and I have to submix some channels in Cubase.

So what's better as host?

Btw. thanks for your answers.

Pulsar2

That was my though and it is.

But host and first card (ULLI etc.) are not identical, are they?

I'd say yes it is, as wel as for the clock