Page 1 of 1
Posted: Fri Dec 10, 2004 8:22 am
by musurgio
Hello,
Any suggestion on how to use my Paris system with XTC ?
When I try to insert an XTC plugin from within Paris the XTC plugin is loaded the interface opens but no sound passes thru...
Any clew ?
Regards,
Dimitrios
Posted: Fri Dec 10, 2004 4:24 pm
by garyb
are you using an xtc card? i believe that for there to be even a chance for xtc mode to work with paris, the io card must be removed and plugged(made into an xtc card) since paris uses it's own io. just guessing, of course. i know nothing of paris's vst and asio implementation.
Posted: Fri Dec 10, 2004 4:36 pm
by musurgio
Dear Astroman and Garyb thanks for suggestions I will try all.
Regarding Paris, Paris doesn't use ASIO at all.
Secondly it recognises all VST /DX.
UAD-1 cards and powercore are recognized with VST wrapper app.
But the same wrappers (tried 2) although they appear as XTC plugins in their wrapped window and XTC is loaded no sound gets thru.
I am using Pulsar II on that computer without running SFP at all.
I readabout this XTC SFP project but as I see it is only for ASIO related appz I guess.
I just would like to use Pulsar as XTC (powered plugins ) from within Paris.
Any suggestions ?
Regards,
Dimitrios
Posted: Fri Dec 10, 2004 5:13 pm
by garyb
you need to remove the io card from your pulsar and contact your dealer or distributor about getting a plug to replace it. then you will have an xtc card and xtc mode should work.
Posted: Fri Dec 10, 2004 6:41 pm
by musurgio
wow didn't know that !
So you think that this causes the xtc plugz not to work ?
What plug is that ?
I am located in Greece and I bought from USA so it is a tad difficult to get hold of it.
Maybe I could buy one from electronics shop.
Any idea what this actually is ?
Regards,
DImitrios
Posted: Fri Dec 10, 2004 6:44 pm
by garyb
contact creamware germany. you need to get it from them.
again, this is to the best of my knowledge.
<font size=-1>[ This Message was edited by: garyb on 2004-12-10 18:44 ]</font>