PlanetZ forums - scopeusers.com

In XTC mode I can see both powersampler & pulsarII I/O in the ASIO configuration box.
When I set powersampler i/o, after reloading I haven't it active.
I need powersampler output activated to monitoring recordings.
can someone help me?

i have just do disconnect pulsarII from my pc:

now I have only powersampler in my pc.
under cubase, in i/o settings i can find only powersampler:

i check analog out & analog in, check "reload", then in VST connection:
Powersampler analog i/o is not active!
help me please

you need to properly set up your xtcproject.pro in sfp/app/xtcapp. it is set up similarly to a normal project in scope mode

Mm I think the project that XTC uses is SFPAppXTCAppXTC.pro, you could try loading the project in SFP and see if the Powersampler Analog Dest modules are present in the project.

On 2004-11-24 23:34, symbiote wrote:
Mm I think the project that XTC uses is SFPAppXTCAppXTC.pro,

that's correct except it's xtcproject.pro not xtc.pro......

Oops, thanks for pointing it out ^_^

now i can use two outputs to monitoring recordings but, if i set directplay to PulsarII Analog output and i press the directplay function on a sinth these message error is prompted:

it seems that powersampler outputs can't be loaded in XTC. is it real?

is there someone who use PulsarII & Powersampler (or luna) in XTC mode?

I hope edit cset.ini can be a good idea, but I don't know how.


note: in my driver list powersampler card is: "creamware dsp board"

<font size=-1>[ This Message was edited by: burdello on 2004-11-25 07:22 ]</font>