PlanetZ forums - scopeusers.com

My Win XP is configured to 'Standard PC' and not ACPI. My existing card the Audiophile 2496 works fine but I had a look at the IRQ settings that the card was on and I'm a bit worried about what will happen when I install the Scope Pro card (I'm removing the Audiophile). My IRQ's are as follows:-

Resources by type:-

Only PCI IRQ 5 and 11 are used

PCI 5 Intel(R) 82801EB Ultra ATA Storage Controllers
PCI 5 Intel(R) 82801EB USB Universal Host COntrollers - 24D7
PCI 5 Intel(R) 82801EB USB2 Enhanced Host COntrollers - 24DD
PCI 5 M-Audio Delta Audiophile
PCI 11 Intel(R) 82801EB SMBUs Controller - 24D3
PCI 11 Intel(R) 82801EB USB Universal Host COntrollers - 24D2
PCI 11 Intel(R) 82801EB USB Universal Host COntrollers - 24D4
PCI 11 Intel(R) 82801EB USB Universal Host COntrollers - 24DE
PCI 11 NVIDIA GeForce FX 5900XT

Resources by connection:-

The same as above

There looks like a lot a stuff sharing the IRQ with my soundcard ?
What do you suggest I do when I install the scope board.
I cannot disable the USB ports in the BIOS because I use them in the other 2 partitions I have.

Do I simply need to put the cars in a different slot ? - I could get rid of my old dial-up modem - I have broadband now.

Thanks for any advice

My motherboard is an ASUS P5P800

<font size=-1>[ This Message was edited by: strav100 on 2004-11-13 08:54 ]</font>

Perhaps I'll stick it into in the PCI slot my old modem is in and see what happens......

good idea.