Page 1 of 1
Posted: Wed Nov 10, 2004 6:30 am
by Yorkeire
Hi, I am running Windows XP but after formatting my drive, XP wont recognise Scope.
Has any1 else encountered this and if so could they PLEASE HELP ME!!!!
Very Frustrating
Posted: Wed Nov 10, 2004 8:09 am
by Counterparts
Have you re-installed the Scope drivers?
Is the card detected in the BIOS?
If yes to both of the above, you could try re-seating the board in its PCI slot.
By the way, did you...
a) re-format your drive, then re-install XP and SFP
or
b) re-format a non-system drive and then XP subsequently couldn't detect the card?
Royston
Posted: Thu Nov 11, 2004 5:02 am
by Yorkeire
Hi Royston
I formatted the the drive using XP as my boot disc (cd)
I do not think the system is picking up my pulsar, even when I change the PCI slot.
Would you have any other ideas
Cheers
Laurence
Posted: Thu Nov 11, 2004 5:29 am
by Counterparts
So, you formatted the system drive, then re-installed XP and the Scope software? (I'm still not sure exactly).
Under device manager, is there a '?' icon for the scope card (i.e. unknown device)?
Royston