PlanetZ forums - scopeusers.com

hi
i'm exploring my modularIII and want to use the ps32 to control step changes in the step sequencer.

In the settings of the PS32 I can't put in the values I want to, for the note value. For exemple the 3 step can't be triggered by note 35 36 37 or 39.
What's going wrong ?

Thanks

_________________
<a href="http://hurpasard.free.fr"> my music </a>
<a href="http://peinturesurlenet.free.fr"> my paintings </a>

<font size=-1>[ This Message was edited by: gustav on 2004-09-27 10:39 ]</font>

p...

<font size=-1>[ This Message was edited by: fra77x on 2004-09-30 04:01 ]</font>

Remember that if you want to change note values to control certain buttons, these notes must be available and not taken by another button. If you try to change preset1 from 36 to an higher number, it will jump to 43 as all the numbers in between are taken...al you have to do is to change temporarily the other numbers to a different range, then assign them as you want.

Thanx for the hints _ I will try asap

thanks to alfonso
its working all fine
you only have to know

bye