PlanetZ forums - scopeusers.com

Hi,
I want to use a Luna II with I/O-expansioncard together with a Pulsar SRB or Pulsar 1. It works, but I can only use the ULLI-settings of the Pulsar 1 down to 13ms.

I remember that I read here about the fact, that if you combine two cards of the first and second generation it would be possible to use the lower ULLI-settimgs of the newer card if you use their I/O's.

(The search-engine of the forum isn`t the best, I didn't find the thread).

How to setup, is it possible to combine these cards as explained?

Bye

Christian

When you connect multiple CW DSP boards, one card handles the drivers. It's automatically set nowadays in SFP afaik, but if that fails there's a cset.ini tweak that lets you assign the board order manually. When Luna is set to board0, you can use the better latency of that card.

It's all pretty straight-forward when you install it.

Hi atomic,

thanks for ultra-speed-reply, I'll try it!

Bye

Christian