Page 1 of 1
Posted: Wed Jun 30, 2004 12:05 pm
by bronYaur
someone can give to small explanation on like using STM2448 recording BUS,in that way the tracks are sent to recording bus?,how using the same ones as Group BUS??
every clarification is appreciated
Thanks
<font size=-1>[ This Message was edited by: bronYaur on 2004-06-30 13:26 ]</font>
Posted: Wed Jun 30, 2004 5:04 pm
by Plato
for recording you'd plug the bus output into, say ASIO dest
for using it as a group, there's a green (when illuminated) button to bring the bus channel into the main mix.....go to the bus page of the STM - it's at the bottom.
So really it's just a question of defining where you want the signal to go.....
There's no reason why you can't have one bus defined as a recording output, and the others as group channels.
[I presume you know how to send a channel down the bus ?]
<font size=-1>[ This Message was edited by: Plato on 2004-06-30 18:08 ]</font>