Page 1 of 1
Posted: Thu May 06, 2004 4:13 pm
by fidox
hi there !ยจ
i know that there have already been this post, but since it's long time from there i'll ask again,
is there "ANY" way to connect 4 creamware cards together and is there just 3-way S-TDM cable or can anyone send me or make 4-way S-TDM cable ? any experts here ?
you'll help me alot, since i'm seriously thinking to buy another creamware card , but i don't want to sell any old one,
second question;
or maybe if i have another computer, what i need then to connect cards together, to control both music systems, with same quality ?
thanks a lot,
please anyone with 4 card system contact me
matej
Posted: Thu May 06, 2004 6:57 pm
by siberiansun
"up to 3 boards from the SCOPE range seamlessly cascadable using the S/TDM Bus"
that's what cwaudio.com says.
so if anyone knows for sure, it's gotta be some tech wiz at cwaudio.com.
i for one have never heard of anyone using 4 (!) cards together.
UAD has the same "only 3 cards" policy.
for reasons i'm probably too dumb to understand.
sorry i couldn't answer your question. good luck anyway!
Posted: Fri May 07, 2004 2:45 am
by R-type
I ask creamware once and they said it was possible on "special" motherboards.
Dunno what the limitation is.
Posted: Fri May 07, 2004 4:20 am
by deejaysly
R-type, did they not tell you what that "special" feature is?
I have a spare Luna and Pulsar II and would love to use 'em.
Cheers.
<font size=-1>[ This Message was edited by: deejaysly on 2004-05-07 05:21 ]</font>
Posted: Fri May 07, 2004 5:49 am
by fidox
hehe, "special" motherboard, why is always there a secret, would like to hear the model and manufacturer
well if there's no chance to do that, i'd rather go for some hardware synth and forget
creamware for some time, since i don't want to sell my old cards, maybe i'll have another comp. one day and 2 creamware systems, that would be really awsome.
do i need than ADAT card for connecting 2 comp. together and control both system over single mixer ?
thanks
matej
Posted: Fri May 07, 2004 6:14 am
by garyb
real engineers can build their own "special motherboards.
i doubt that anyone else is going to pull that trick off with a stock consumer mobo.
Posted: Sat May 08, 2004 5:28 am
by aMo
The guy I sold my Scope card to had 4 pulsars in one computer, it needs some soldering to get it to work, but it is possible..
He also soldered something that made all his PCI-ports work on one IRQ..
<font size=-1>[ This Message was edited by: aMo on 2004-05-08 06:29 ]</font>
Posted: Sat May 08, 2004 7:08 am
by R-type
I can set 4 pci slots to 1 IRQ in my bios.