Page 1 of 1
Posted: Sun Apr 18, 2004 6:30 am
by webbunny
Simple, straightforward Q.... I wanna know if one will fit in my case - they look HUGE!
Andy
<font size=-1>[ This Message was edited by: webbunny on 2004-04-18 07:34 ]</font>
Posted: Sun Apr 18, 2004 6:54 am
by samplaire
Hi Andy
Following the info found in faq section of the old creamware site: Physical dimensions 31.2 x 10.8 x 1.6 cm
(excluding bracket)
Hope this helps you
_________________
Sir Sam Plaire Scopernicus
<font size=-1>[ This Message was edited by: samplaire on 2004-04-18 07:54 ]</font>
Posted: Sun Apr 18, 2004 7:59 am
by wsippel
The card should be full size, as defined in the PCI and ATX standard.
Open you case, and check if there are some retention clips on the front side of the case (on line with the PCI slots). If your case is standard ATX or E-ATX, there should be such plastic clips, and the board should fit.
<font size=-1>[ This Message was edited by: wsippel on 2004-04-18 08:59 ]</font>
Posted: Sun Apr 18, 2004 4:34 pm
by webbunny
Oh well.... new case time !
Andy
Posted: Mon Apr 19, 2004 3:54 am
by Plato
I had to resort to using a hack saw on my brand new computer to make mine fit.....scary, but it worked.