PlanetZ forums - scopeusers.com

Hello,

I have a Pulsar card which I have used with the Pulsar software since 2001 under Windows 98. Because the system was
stable and reliable, I didn't upgrade the Windows system ( I am still using Windows 98).

Recently the Pulsarsoftware (2.01) suddenly didn't start up at all due to some
conflicts with other programs, so I decided to upgrade my system and to
install SFP 3.1.
The installation went fine, but the problem is now that after I have
started the SFP, Logic 5 cannot find the ASIO drivers (I was using ASIO 2
with the Pulsar platform) whatever I do.

I keep getting the message: can't find Scope ASIO drivers in Logic and when
I go to the driver menu in Logic, I can't select any drivers in the ASIO
menu.

Can you help me out?

you must manually reinstall the NEW driver when installing v3.1(and use 3.1c).

see the readme...

I did reinstall the new driver (SFP asked me to during installation)...

what does the device manager say? i used 98,logic 5.5.1 and sfp3.1c for some time before going to xp with no troubles....maybe the logic install is damaged...

I was using Logic 5.3.0 with Win98 and Pulsar 2.01 with no trouble; Maybe I should reinstall Logic, but I don't think that will help.

3.1c is light years better than v2.check everything and reinstall it all if nessessary,it'll work...

Nitro_1976 wrote:
Maybe I should reinstall Logic, but I don't think that will help.

It helps for Cubase, so I think it will for Logic. My 2 cents...