PlanetZ forums - scopeusers.com

Ive bought a power sampler, i got a cd with it which says scope fusion 3.1b

but when i try and install with it it just
crashes.

I tried to get on the creamware website but it but i could not register because it says someone else is allready registed with this card?

ive also got disks with sts-3000 and power sampler
main studio package and volksampler on but I cant work it out ...?

is there much difference between power sampler 1 and power sampler 2?

thare are other programes on the disk but I bought this disk off a dealer and he doesent know much about it, he just had it as a trade in ...

I was sold it as a power sampler 2, it didnt have a proper box with it or instructions


<font size=-1>[ This Message was edited by: esa on 2004-02-07 16:10 ]</font>

<font size=-1>[ This Message was edited by: esa on 2004-02-07 16:12 ]</font>

<font size=-1>[ This Message was edited by: esa on 2004-02-07 16:13 ]</font>

<font size=-1>[ This Message was edited by: esa on 2004-02-07 16:14 ]</font>

well,your in the wrong forum(should be in problem solving) but i'll help if i can.your dealer should have gotten the transfer before he purchase the device.it may have a problem...(it's a great product and you made a good choice,maybe you got the wrong card though if it's broken...)as to the registration,you will have to contact cw. they will probably try to contact the original owner though and it may take a while.until then,it's hard to say anything for sure....

..also,3.1c is the version of the soft you want.(free once you get the card registered)that stuff is hardcore programming so therefore the tough copy protection....

As far as I know, there should be an STS-5000 with the Powersampler2, while the Powersampler1 only had the STS-3000.