Page 1 of 1
Posted: Mon Feb 02, 2004 12:59 am
by Eternal Advancement
I've recently built a Daw and upgraded to Windows XP Professional. I've done all the tweaks as suggested on this site, and my system works greate except for this one error. I get an error that the 2nixasync Vxd file is not found in the dsp files whenever I load my sts 3000. I've never had this error before, and I'm not sure what is causing it. If anyone has a clue please let me know. I'm running scope fusion platform 3.1a, by the way.
My Computer Specs are:
Pentium 4 2.6 GHZ 800FSB
512MB of 400Mhz DDR Ram
Jaton Nvidia, Dual monitor Video Card
Abit IC7-Mother Board
2 Creamware Cards (Powersampler+Elektra) 6dsp
Windows XP Professional
Thanks.
-Eternal
<font size=-1>[ This Message was edited by: Eternal Advancement on 2004-02-02 01:00 ]</font>
<font size=-1>[ This Message was edited by: Eternal Advancement on 2004-02-02 01:38 ]</font>
Posted: Mon Feb 02, 2004 5:13 am
by wilbertenserink
hi
have you tried reinstalling the sfp software. Sometimes solves troubles with missing files.
good luck
Wilbert
Posted: Mon Feb 02, 2004 7:19 am
by astroman
use 3.1c - no kidding !
Posted: Mon Feb 02, 2004 8:25 am
by Eternal Advancement
I've tried about 4-5 reinstalls and still had no luck. I downloaded SFP 3.1C from the website last night. I'm going to install it later today, so I'll get back to all of you to let you know how that works.
Thanks
-Eternal
Posted: Mon Feb 02, 2004 11:20 am
by Eternal Advancement
WEll, I've tried 3.1c and I still get the same error when I try to load my sts 3000 sampler. Is it possible that some of the names for the vxd files get renamed under windows xp, or am I actually missing a file? If I am missing a file, where can I get it from? Very strange error and not sure what to do. Please let me know what else to try.
Thanks
Posted: Mon Feb 02, 2004 4:26 pm
by bassdude
These re-installs, did you first try a full un-install of the software first?
Posted: Mon Feb 02, 2004 5:05 pm
by Eternal Advancement
I perfomred the uninstall first, and also made sure to delete the install information from the windows registry, and still no luck. Not sure what it could be.
-Eternal
Posted: Tue Feb 03, 2004 8:01 pm
by Eternal Advancement
I got it to work! I had to reformat my hard drive. For some reason, I belive my registry file became corrupt, as well as my scope fusion installation files. After the reformat and re-installation, everything went fine. Now I only have problems trying to load some the free plugins from neutrons website, but I think I may just need to get an updated device file form them. Thank you all very much for your help.
-Eternal