PlanetZ forums - scopeusers.com

Hi all,

I have a Pulsar 2 on order and also came across a Pulsar I at a good price.

Does the order of installation make a difference?

Example, should I install the Pulsar I first while waiting for the Pulsar 2 to arrive?

What if I purchase softsyns using the Puslar I serial number? Will I encounter problems after I install the Pulsar 2 at a later date?

Or should I wait and install the Pulsar 2 first?

Thanks in advance for any advice.
Have a nice weekend,
JK

<font size=-1>[ This Message was edited by: lowjk on 2001-06-29 00:36 ]</font>

i would register new software to the new hardware (p2), but go installing your p1 card for the while you´re waiting for the p2. afaik that makes no difference.

Once you get the Pulsar2, you'll probably want to do a full 2.01 install overtop again, followed again by the 2.04a update, just to be sure it's all installed and working with both cards.

Also, you might start trying to procure an STDM cable, they seem tricky to come by, and sometimes take a week or two to get. Contact your dealer first...