Page 2 of 2
Re: SCOPE 5- Cannot start the SCOPE application error code 0001
Posted: Fri May 29, 2009 5:48 am
by voidar
fidox wrote:well, strange is , that i can't run Optimaster, but i have key registered for Optimaster , i even see it under Scope 5 - registry window, but can't run it,
i can see registration window all the time, whatever i do
Matej
The PSY Q and Optimaster are updated. Use the new ones...
People, be carefull when copying stuff from your old install!
The updated STW verbs seem to be more PCI efficient
. I could load an ambience, plate, CD and DAS verb without problems.
Really looking forward to transfering my 4.5 project to this!!
Re: SCOPE 5- Cannot start the SCOPE application error code 0001
Posted: Fri May 29, 2009 6:44 am
by fidox
voidar wrote:
People, be carefull when copying stuff from your old install!
yup, true,
after clean install again, Optimaster works fine
Re: SCOPE 5- Cannot start the SCOPE application error code 0001
Posted: Wed Jun 03, 2009 1:27 pm
by rhythmaster
I got 2 key-files from Ralf and with both I get still the "error code 0001".
I have the new drivers installed, and rebooted the PC.
So could it be still a wrong keyfile???
THanks
Re: SCOPE 5- Cannot start the SCOPE application error code 0001
Posted: Wed Jun 03, 2009 9:36 pm
by eliam
I received 3 different key files, none of which is accepted during installation...
Re: SCOPE 5- Cannot start the SCOPE application error code 0001
Posted: Wed Jun 03, 2009 11:50 pm
by rhythmaster
Sorry it was my mistake.
The 2nd keyfile works. I destroyed it by moving the lines because I thought they were mixed up and altered the sequence of the keys.
Now SCOPE 5 works.
But I stepped back to SCOPE 4.5 because of no (officially released) XTC-Mode (I got a Blue Screen when trying the XTC-SCOPE-5 hints)
and I wait until the new bugs are patched!!!!
So no SCOPE 5 for me so far!
Harry