What's wrong with just recording your automation of Scope mixer channel volumes as a midi stream in your sequencer as Garyb suggested? You can then edit the automation in fine detail as well, which is practically essential. Sometimes you can even forget about recording a midi stream for volume automation & just draw it in the sequencer (ramps for fades, steps for cuts etc), which is what a lot of people do when making electronic music.katano wrote:the automation stuff is also a problem for me. as i do all the mixing in scope mixers, automation (i.e. channel volume) should be done at the same place in processing, means in scope mixer. if you automate the stuff in your sequencer, you'll loose the ability to use a gate, compressor in scope, because they are volume dependent (i.e. for channel volume).
Is it that you have an issue with the resolution of midi controller automation or something?
Mark