Combinations two Pulsar II

fran · Post by **fran** » Sat Jul 10, 2004 8:54 am

I have buy a second Pulsar II (second Hand)
How much cable S/TDM need I ? one or two

This second Pulsar is registration for first propietary, can I make
some thing?

Will I have some problem with my activations keys when I put this new
card?

Please, I need support. Thank you very much

Ricardo · Post by **Ricardo** » Sat Jul 10, 2004 9:40 am

Only one STM is fine.
Your second card should act as extra DSP only. Any extra devices registered to the new card should work fine. Just make sure you update your activation keys file before you install SFP.

Post by **garyb** » Sat Jul 10, 2004 12:56 pm

if you want extra stdm cables check with yout dealer. only one is nessessary, but two is better. the price will be from free to $15.

blazesboylan · Post by **blazesboylan** » Sat Jul 10, 2004 5:08 pm

I spoke to Ali at CreamWare last week and the "official" advice is: less is better. Apparently the more STDM cables you get, the more likely system instability is. Therefore stick to 1 unless you get a message that says something like:

Unable to route from board 0 to board 1

Unless you have a massive project, 1 cable will be more than enough. (By "massive project" I mean: hundreds of devices with virtual cables connecting them all. I'll post an example pic shortly.)

Cheers,

Johann

Post by **garyb** » Sat Jul 10, 2004 11:24 pm

good to be informed!