Scope 5.1, XITE-1, WinXP 32Bit

[syberxa]

Bud Weiser,

When you openend Studio One after closing scope in XTC mode, did Studio One find the Xite driver?

I am trying to enable XTC on the Presonus Stduio One aswell. Already enabled XTC in scope and opened the Scope XTC project., modified and closed Scope and openend Stduio One. However Studio One is not able to switch to the Xite-1 and loads it drivers, so there is no I/O available. And same problem here not scanning for the XTC plugins.

regards
Shatis

[Bud Weiser]

Bud Weiser,

When you openend Studio One after closing scope in XTC mode, did Studio One find the Xite driver?

I am trying to enable XTC on the Presonus Stduio One aswell. Already enabled XTC in scope and opened the Scope XTC project., modified and closed Scope and openend Stduio One. However Studio One is not able to switch to the Xite-1 and loads it drivers, so there is no I/O available. And same problem here not scanning for the XTC plugins.

regards
Shatis

Hi !

I didn´t and don´t use XTC mode.
After I had the issue PS 1 Pro didn´t accept the SCOPE devices DLLs in my vstplugins folder, I moved ´em elsewhere and never tried again.
So,- PS1 Pro v2 hosts my VST plugins and Reason 6 is rewired to PS1 pro v2, then I route VST and Reason tracks/outputs to SCOPE 5.1 ASIO input module into 2448X mixer and mixer busses to ASIO output module back to VST host.
For the time being, I route MIDI form VST host to SCOPE via MIDI OX and have the alternative to route MIDI from external machines to SCOPE via XITE-1 MIDI In and record in S1 prov2.

In fact, I´m waiting for Open SCOPE/SCOPE 6 (and ParseQ) showing up to get rid of the MIDI OX solution.

Bud