PlanetZ forums - scopeusers.com

YAY. replaced the two caps on the output and the Luna works both chanels now. Thankyou.

Although the existing caps are surface mounted, there are also holes on each connection where they could be mounted through the board.

Ok so I have the caps off but I dont think I can swap them as the way they are soldered from the top and underneath the cap itself makes it very difficult to solder or see if it is soldered properly. Also the legs dont fit the hole spacing to solder in the traditional way through the holes. I think ...

Are you meaning the four small metal cased caps running along behind the I/O sockets on the underneath of the board? or maybe just two of them by the output socket?
should i just unsolder and resolder? or just heat uo and reflow the solder?
If this is even what you mean

@valis @garyb. Yes TRS y cable to 2 mono Output 1 and 2. This is the first thing i tried and made up a new custom y cable. I even wired an open plug and connected wires. Also all my plugs test with meter correctly. So connecting directly to the solder behind the output socket (as mentioned by ...

@astroman Thanks for the answer. I will check the bottom of the board.
It did not hasppen in a session. Its not used much. The trs output cable generally stays unmoved and plugs into an amp for monitoring.
The zlink and A16 ultra stll work.

@valis What do I look for? Bulging? They are looking ok as far as I can see?

Hi Dug out the old Luna card and been using on Win 10 for a few months and i pulled up some old songs to mix. Running well, even on lowest latency setting. Left Output Channel just stopped working and cannot figure out if the card has died. Both chanels show meters on my daw (reaper) and scope ...

Thanks. Yep sorry the zlink just looks like FireWire...

Is adat compatibility an ongoing thing? Searching I find lots of discontinued products?

Hi. I have been away from recording for a long while - over a decade. I used to run a creamware Luna Ii and zlink adapter via PCI to the A16 ultra. I still have all of these but cannot get Luna working with current PC. I think it's best in my situation to maybe go for another system (sorry I did ...